| [Help Me] Linksys 3102 Drops PSTN dialtone I recently set up a 3102 to route my Sipgate number to a PSTN line. I've set up numerous PAP2's and 2102's so it was no problem setting up my Sipgate credentials and the 3102 routed to PSTN just fine for about 30 minutes. After that, when I call in, the Sipgate number just keeps on ringing - no PSTN dialtone. The 3102 is set to factory defaults - i've not messed around with any settings other than Sipgate user setup on the PSTN line.
If I reboot the 3102 - it again works fine - but then the PSTN stops as above.
Can anyone suggest a solution - it's very hard to find any troubleshooting FAQ's on this.
Thanks!
|
|
 slpip3
join:2007-02-20
Springfield, VA | »www.freepbx.org/support/document···-freepbx |
|
| maybe the op should post in a linksys forum |
|
