| [HELP] [N/H] Cisco/SA D9477/9479 - Port Assignment w/o DNCS I am looking for command references or something similar for the Cisco/SA D9477 and D9479 QAM modulators. I need to run this in standalone mode without a DNCS controller. I have booted them in standalone, but I do not have the commands to assign the ports. I know we have done this before, but can't find the paperwork.
Any input would be appreciated. Thanks.
Mike |
|
|
|
| The command is:
Pass <ASI-PORT> <START-PID> <STOP-PID> <RFPORT>
pass 1 0x0000 0x1fff 1 =RF OUTPUT 1
pass 1 0x0000 0x1fff 2 =RF OUTPUT 2
pass 1 0x0000 0x1fff 3 =RF OUTPUT 3
pass 1 0x0000 0x1fff 4 =RF OUTPUT 4
you can only pass 1000 PID's to a rf port. |
|
