| [Info] NAT-t Support on Cisco 1941 I would like to find out whether or not the Cisco 1941 series router supports NAT-t. I am would like to run an IPSec tunnel over the router to the remote data centre using my existing APN service. This is to allow my users on the LAN to be able to send print requests to the Print server located at a remote data center and the printer is situated on site. |
|
| Yes. Here is a config using IOS 12.2, I suspect 15.x code should take most if not all commands seamlessly.
Regards |
|
| Thank you hellfire, that was very informative..... |
|
