| [CA] 92606 gradual drop in downstream speeds Hey Guys,
I've been wondering why my speeds were getting worse downloading from steam servers, turns it it wasn't steam but rather an issue with COX.
I have SB6120 bonding 3 channels, latest firmware 1.0.51.
SB6120 > Cisco E4200 > PC over Cat6. Usually I can get my rated speeds fine, but now I'm getting less than 40% of it....
Funny thing is my pings are fine, upload is also fine, just downstream is horrible.....
»www.speedtest.net/result/1752774156.png
Downstream Bonding Channel Value
Channel ID 199 200 201
Frequency 579000000 Hz 585000000 Hz 591000000 Hz
Signal to Noise Ratio 37 dB 37 dB 37 dB
Downstream Modulation QAM256 QAM256 QAM256
Power Level
The Downstream Power Level reading is a snapshot taken at the time this page was requested. Please Reload/Refresh this Page for a new reading
-2 dBmV -2 dBmV -2 dBmV
Upstream Bonding Channel Value
Channel ID 1
Frequency 23810000 Hz
Ranging Service ID 238
Symbol Rate 5.120 Msym/sec
Power Level 40 dBmV
Upstream Modulation [3] QPSK
[3] 64QAM
Ranging Status Success
Signal Stats (Codewords) Bonding Channel Value
Channel ID 199 200 201
Total Unerrored Codewords 32625296 32625391 32625393
Total Correctable Codewords 15 11 12
Total Uncorrectable Codewords 1649 1562 1560 |
|
 dvd536as Mr. Pink as they comePremium
join:2001-04-27
Phoenix, AZ
kudos:4 | Signal levels all look good.
are speeds still bad *without* the router in the mix? |
|
| It's still being extremely inconsistent.
I just tested and I'm only getting 22mbps, usually I get 30-50 with powerboost.
I don't believe it's my router at play here, but I'll test without router very shortly, I think it's time to call COX :/
Just tested again, i'm getting my original speeds. I was seriously debating on upgrading to Ultimate, but with these inconsistent speeds, I may pass for a bit. |
|
