dslreports logo
 
    All Forums Hot Topics Gallery
spc
uniqs
9

JC_
Premium Member
join:2010-10-19
Nepean, ON

JC_

Premium Member

Re: Firmware + Sagemcom Modem + Help

Here is a list of all the command that can be used in the system shell after you enter VDSL mode.

      BME Reference board API Menu
Ikanos Communications Copyright 2000-2008
             Version 6.10.1.7 VOX180
=========================================
 
    2) Initiate Reset BME command
    3) Configure System Provision (default values)
    4) Configure Port Provision
    5) Initiate Port Start command
    7) Initiate Port Stop command
    9) Start Loopback Test
   10) Request Brief Port Status
   11) Request Extended Port Status
   12) Display Performance Counters
   13) Get Near End SNR Margin and Attenuation
   15) Display User Logs
   16) Clear User Logs
   20) Display this menu
   21) Modify Port Provision
   31) INI CRC Threshold
   41) Port Error Count Management
   42) Event Log Management
   55) Board Configuration Management
   56) OAM Options Mask Setting
   57) Performance Management Parameter Configuration
   58) Trigger PM Failures
   59) Bitloading Per Tone
   62) GPIO Test
   70) Maintenance Mode
   72) VDSL2 Double Ended Loop Testing (DELT)
   73) Freeze Mode
   90) BME Firmware versions
   91) EFM Pre-emption
   99) Log off/ Go to auto mode
  114) Clear Performance Counters
  127) System training LED blink rate
  131) VDSL CRC Threshold
  140) Internal EOC Commands
  141) Overhead Message Commands
  143) Remote Ethernet Status Report
  150) Bit Swap Commands
  212) Display All Performance Counters
 
JC_

1 edit

JC_

Premium Member

I was going through the config file and I found this on line 1029-1062, it looks like user 3 is the Bell admin account. Removing the port will allow you to login over the LAN but it doesn't offer any additional config options in the menu.

(user
      (0
        (username(admin))
        (password())
        (full_name(Administrator))
        (email())
        (permissions
          (mgt(1))
          (fs(1))
          (telnet(1))
        )
        (notify_level
          (0(none))
          (1(none))
        )
      )
      (3
        (username(001BBF-NQ1113901014485))
        (password(7f1d6bf3c8fcf9211c7f02975c02f7e2))
        (full_name(Administrator))
        (email())
        (permissions
          (mgt(1))
          (fs(1))
          (telnet(1))
        )
        (notify_level
          (0(none))
          (1(none))
        )
        (port(50001))
      )
    )