dslreports logo
site
 
    All Forums Hot Topics Gallery
spc

spacer




how-to block ads


Search Topic:
uniqs
389
share rss forum feed

kracksmith

join:2004-07-14
Fullerton, CA

[Config] cisco micro webserver 100 config

I just acquired a cisco micro webserver 100 with zip drive.

i serial port and configured the IP address, subnetmask, and GW

config nvram internet-address 192.168.1.x
config nvram netmask 255.255.255.0
config nvram default-gateway 192.168.1.1
config nvram write
reboot (to save the changes permanently)

Well after the reboot I am able to ping the IP address fine but I'm not able to web console.

Anybody really old that worked on this when they were a young buck?

Any thing to help me get this working.

HELLFIRE
Premium
join:2009-11-25
kudos:18
What... The... Crack?! No pun intended...

When did these go EOL, I wonder...

Regards

kracksmith

join:2004-07-14
Fullerton, CA
yes of course i'm messing around with EOL, how else can i afford Cisco things.

well, I got it so i need to try to configure it to make it work. Since this is a small appliance and my web pages are all static plus i can leave this on 24/7 and not worry about wasting electric, why not right.

from the manual i read i just need to configure an IP which I did and i should be able to web console in to configure more settings. well something is missing as I can't web console in. manual doesn't state what i'm missing since i can't web console in.

so i was just curious if there are any old birdies here that might know off hand.

oh, i didn't see the link, so i guess i need to some how get the ZIP software to go further. anybody got this stashed away?

HELLFIRE
Premium
join:2009-11-25
kudos:18
reply to kracksmith
Snuck a quick look at work if there was anything still hiding in the Downloads section of CCO, no dice.

I'm quite interested what this little puppy can once the software's installed.

Regards