|reply to RyanG1 |
Re: [Config] Cisco 1921 problems communicating between VLANs
It is a layer 3 switch and will be doing some of the routing itself. VLANS 5 and 100 will be on a separate switch that is not a layer 3 switch. I will add these to the config I just wanted to get VLAN 1 working first.
I know something is not configured properly thats why I am posting. The workstations on 192.168.1.0 cannot see the switch at 192.168.101.2
I removed the zone associations. I dont know what you mean it never happens.
Unfortunately the overly complicated configuration is out of my hands. Your right there has been a lot of good advice on the threads. I dont feel I have ignored it. I reloaded the router instead of using their old config and I have a basic setup implemented without the firewall so I can setup the rest of the network.
The config files changed drastically because I took the advice of a previous poster and scrapped the config with a lot of un needed services configured for a earlier one with just 1 vlan configured.
Blunt is fine by me. I just want to get this up and running so I can forget about it. I have completed all the steps in your checklist but I am still experiencing the same problem as before.