 Doctor OldsI Need A Remedy For What's Ailing Me.Premium,VIP
join:2001-04-19
1970 442 W30
kudos:18 | reply to LeftOfSanity
Re: 2005 Nissan Altima 2.5L No Start Condition No power could be clogged exhaust/converter and or clogged fuel filter/bad fuel pump. You still have some diagnostics ahead of you unless you drive it to a Dealer or a shop.
--
What’s the point of owning a supercar if you can’t scare yourself stupid from time to time? |
|
| said by Doctor Olds:No power could be clogged exhaust/converter and or clogged fuel filter/bad fuel pump. You still have some diagnostics ahead of you unless you drive it to a Dealer or a shop.
Managed to drive it Autozone, they said I should take it to the dealer to get scanned.
They pulled stored codes:
P1031 - A/F Sensor 1 heater control circuit low
P0725 - Engine Speed signal circuit
But they might have been from me unplugging sensors.
Someone mentioned it sounds like it is running in 'Limp Mode' and I should try to reset/clear the ecu.
--
"I'm against picketing, but I don't know how to show it" - Mitch Hedberg |
|
Doctor OldsI Need A Remedy For What's Ailing Me.Premium,VIP
join:2001-04-19
1970 442 W30
kudos:18 | said by LeftOfSanity:They pulled stored codes:
P1031 - A/F Sensor 1 heater control circuit low
P0725 - Engine Speed signal circuit
Someone mentioned it sounds like it is running in 'Limp Mode' and I should try to reset/clear the ecu.
2005-2006 Nissan Altima Factory Service Bulletin OBDII Code P1031
»ww2.justanswer.com/uploads/badda···0691.pdf
Engine Speed Sensor P0725
»x.nissanhelp.com/forums/altima/1···elp.html
To reset the codes :
2002-2006 Nissan Altima Forums > F.A.Q 2002-2006
Reload this Page How-to: Read and Reset Check Engine/Service Engine Soon Light
»www.nissanclub.com/forums/f-q-20···ght.html
--
What’s the point of owning a supercar if you can’t scare yourself stupid from time to time? |
|
| reply to LeftOfSanity
Sanity, did you find the problem with your 'crank,no start' with your Altima? My 2002 2.5 Altima does the same thing, BUT I have to disconnect the 'Camshaft sensor', as opposed to the 'Crankshaft sensor', in order for it to start up. I have acceleration but not near the full torque power I'd expect. New crank & cam sensors but still same problem. 3 expert mechanics are baffled. not spending another dime for new parts in order to 'hit & miss' the issue. |
|
