dslreports logo
 
    All Forums Hot Topics Gallery
spc
uniqs
32

Martin
Premium Member
join:2005-05-05
Blainville, QC

Martin to a_mckie

Premium Member

to a_mckie

Re: [TV] Fibe 2202 receiver doesn't play nice with 2262 PVR

- Disconnect the power of the two receivers.

- Reconnects the PVR 2262 only until it displays three point on the screen, it display three points immediately disconnects again, repeated three times the process until the point to be replaced by two gear.

- Wait completely rebooted until the TV picture appears, left open.

- Repeat the same process on 2202 receiver.

- The problem should be completely repaired.
ruggs
join:2012-03-26
Ontario

ruggs

Member

said by Martin:

- Disconnect the power of the two receivers.

- Reconnects the PVR 2262 only until it displays three point on the screen, it display three points immediately disconnects again, repeated three times the process until the point to be replaced by two gear.

- Wait completely rebooted until the TV picture appears, left open.

- Repeat the same process on 2202 receiver.

- The problem should be completely repaired.

How long does the soft DRA take? I know the hard DRA is about 17 min, but never tried the soft DRA

Luke_gaud
@bell.ca

Luke_gaud to Martin

Anon

to Martin
Hello,

Martin can you explain the solution in french i think you will help lot of people?

Thank's

TigerLord

join:2002-06-09
Canada

TigerLord to Martin

to Martin
said by Martin:

- Disconnect the power of the two receivers.

- Reconnects the PVR 2262 only until it displays three point on the screen, it display three points immediately disconnects again, repeated three times the process until the point to be replaced by two gear.

- Wait completely rebooted until the TV picture appears, left open.

- Repeat the same process on 2202 receiver.

- The problem should be completely repaired.

-Débranches l'alimentation des deux terminaux

-Rebranche le PVR2262 en premier jusqu'à ce que trois points apparaissent. Si les points aparaissent immediatement, debranche et rebranche, trois fois, jusqu'à ce que les points deviennent des icones d'outils (?)

-Répeter l'étape prédécente avec le 2202

-Le problème devrait être réglé
cool50
join:2012-08-26
Pierrefonds, QC

cool50 to Martin

Member

to Martin
Thanks Martin. I have same issue and it fix after follow your instruction. You are the man