dslreports logo
site
 
    All Forums Hot Topics Gallery
spc

spacer




how-to block ads


Search Topic:
uniqs
1
share rss forum feed

eXest7

join:2012-10-05
Glendale, AZ
reply to eXest7

Re: [Config] Cisco 1921 Config.. Please help!!

Thank you guys so much for all the help! I think I'm going to take HELLFIRE'S advice and start with a bare config.. I need the practice anyway! What is the best way to get it back to a bare config?
About the NAT table.. I know it's probably messed up, but I was kind of lost as to how to do it. So Gi0/1 is where I have my cable internet hooked up which my building uses for it's internet and my VPN users use to connect with our network for VoIP and access to our servers, however, then we also have an MPLS network that ties our 3 buildings together. The MPLS comes in on Gi0/0. So the routes for 192.168.1.0 and 3.0 are for our 2 other buildings. Currently we have an RV082 at each location and I was just trying to copy the settings from the RV082 and apply them to the Cisco 1921. If any of you have some good pointers on how this should be set up correctly, I would be very appreciative!!
Again, I appreciate all of the help and will post any updates as I work through this!

Mike