grohgregDunno. Ask The Chief
Dawson Springs, KY
|reply to suceress |
Re: [HN7000S] Any HN7000S users losing signal @ same time every
Push-Pull test is dead simple. It helps to have two people - one at the computer, one at the dish - but you can also do it yourself with a wireless laptop.
Open a browser to »192.168.0.1/fs/advanced/advanced.html
Select Antenna Pointing
Do not check OPI
Do not check ACP
Click Check Signal Strength
A small window will then open. That's your receive signal strength.
Stand behind the dish, watch the signal strength. Assuming you're right handed, you'll likely be holding the laptop on your right side. Push on the left side of the dish. Pull on the left side of the dish. If you can reach the top of the dish, pull - then push. If not, do it from the bottom of the dish. If any of those 4 motions increased your signal, you have a pointing error. From there it should be easy enough to figure out which way to make the correction.
Make sure you Exit the pointing utility and close the browser when you're done. Your satellite/transponder/gateway by the way, can be found with a browser as well. Go to 192.168.0.1 and click the System Info button. The info is in the Satellite box, under Longitude/Receive Frequency/Router Address.
HN7000S - 98cm Prodelin/2w "pure" Osiris - ProPlus - G16/1001H - NOC:GTN - NAT 184.108.40.206 - Gateway 220.127.116.11 - DNS 18.104.22.168 and 22.214.171.124 - Firefox 15/MSIE9 - AV/Firewalled by NIS2012