|reply to thedragonmas |
Re: 97 ford crown vic, temp sensor nut blew out, epoxy repair?
sorry about taking so long to get back folks (been a tad busy)
called around to our local junk yards, priced both 97 and 2002, ranges where $150 (you pull it) to $250 (they pull it) for most of them, ouch :| the cheapist one i found was at a local "you pull it" $120 if you pull it. add in the gaskets ($30)
logistics though is an issue, that joints a mile from the nearest bus stop, lugging the tools over there on the bus, spending a couple hours pulling it, then riding back on the bus, considering all the parts id need to pull off of it at the junk yard, think ill just save up for a new intake mani.
thanks for the info and idea's folks. this place is all ways full of helpful folks, much appreciated