dslreports logo
 
    All Forums Hot Topics Gallery
spc
uniqs
8
urbang33k
join:2010-02-13
Canada

1 edit

urbang33k to madmax4

Member

to madmax4

Re: [Internet] Bell Fibe and Sagecom Connection Hub

well thats odd.

sounds like it could be an address conflict??

on your old setup, were you using your own router?

edit: I'll add that I use a voip ethernet ata on my sagemcom and it works just fine.

Pauly
join:2004-05-29
canada

Pauly

Member

first thing first, do NOT use the red WAN/ETH port on the CONNECTION HUB, its not to be used, secondly, it sounds like you have an IP ADDRESS CONFLICT and was blaming your provider ALL THIS TIME. I would try to get to the bottom of the issue before blaming the provider, that way I dont look dumb when it turns out to be my issue all along. hope this helps
madmax4
join:2008-10-25
York, ON

madmax4

Member

Which Provider Bell or Voip? anyway did some research using this intrepid forum and Toro suggested using another router so I put the Sagecom in Bridge mode and used my apple router using PPOE and NAT open. Phone now works fine Polycom 335 using Comwave