dslreports logo
site
 
    All Forums Hot Topics Gallery
spc

spacer




how-to block ads


Search Topic:
uniqs
6
share rss forum feed

Kirby Smith

join:2001-01-26
Derry, NH
Reviews:
·Fairpoint Commun..

1 edit
reply to JPedroT

Flushing the state table

Two approaches come to mind, since the CLI list doesn't seem to have a flush cache (state table) command as my formerly-used Xincom provides in its GUI. One could flush the state table, and only active connections would be re-established. The Xincom state table was 100k, and the USG 50 table size is only 10k, so the USG is more sensitive to pushing the state table limit. Thus, a flush command would be convenient.

Using the CLIv2 manual as a guide, one could use Table 66 commands to create a rule that greatly reduces the session count, and then after it was saved flush the restrictive rule. Check the state table count on the dashboard to see if it works. I would worry about how low the number of sessions can be before one is locked out.

Alternatively, using the Table 192 commands, one could set the session timings very short, and then return them to wherever they were set. (Note that for BitTorrent, the default settings can lead to a very large number of sessions hanging on because BitTorrent sessions are rarely closed properly.) I know shortening the timings work for all sessions that are hanging on and not active. This approach will not eliminate an active session that is using a firewall rule.

Both approaches are more tedious than rebooting.

kirby

P.S. After 78 days of uptime, my USG 50 has blocked 1.8 billion WAN to Zywall hits. Beat that, Safariland and Ceradyne!