reply to David
Re: POTS Splitter Installation Help Ok, thanks. So your diagram made it clearer, but to be 100% clear, I understand the splitter connections and that a single wire jumps between the NID/splitter, but the jumper is connected to the NID on the EBN posts correct? In other words I am not disconnecting the wires connecting the telco side to the customer side and jumping from the telco side directly, correct? And the jumper wires from the splitter's posts (o/ow and bl/blw from your diagram) are connected directly to my inside wiring within the NID. The existing IW are no longer connected at all to the EBN and the only connection from the EBN is to the jumper between the NID and the splitter. Is that all correct? If so, what kind of connections did you make between the jumper and exising IWs? Is twisting/taping sufficient? Should I solder/heat shrink tubing? Is there a small crimp on connector that would make this easier? Thanks.