Ed B join:2012-12-06 Parrish, FL |
Ed B
Member
2012-Dec-6 10:50 am
[Tampa] Cisco 8742 IRIs it single band controlled or dual band? |
actions · 2012-Dec-6 10:50 am · (locked) |
BHNtechXpertThe One & Only Premium Member join:2006-02-16 Saint Petersburg, FL |
You referring to the remote control? What is the application? |
actions · 2012-Dec-6 11:15 am · (locked) |
Ed B join:2012-12-06 Parrish, FL |
Ed B
Member
2012-Dec-6 11:26 am
Purchased an ir kit over hdmi and in trouble shooting the question was asked if the box was single band 38khz or dual band 56khz the sender/receiver that shipped was single but the newer senders/receivers are dual @ 56 and backwards so I couldn't find the info about the box online so I consulted this forum which seems very knowledgeable. The question I guess is if its 38khz replacing them wouldn't help so I'm wondering if I need to move on to another ir kit. |
actions · 2012-Dec-6 11:26 am · (locked) |
BHNtechXpertThe One & Only Premium Member join:2006-02-16 Saint Petersburg, FL |
to Ed B
Well let me make a quick inquiry. This is a first for this type of question but good info. So we know what IR kit did you purchase. |
actions · 2012-Dec-6 11:44 am · (locked) |
Ed B join:2012-12-06 Parrish, FL |
Ed B
Member
2012-Dec-6 12:06 pm
|
actions · 2012-Dec-6 12:06 pm · (locked) |
BHNtechXpertThe One & Only Premium Member join:2006-02-16 Saint Petersburg, FL |
to Ed B
Thank you...
The front eye is 56khz only and is located 1/8" to the right of the front USB jack. |
actions · 2012-Dec-6 12:43 pm · (locked) |
Ed B join:2012-12-06 Parrish, FL |
Ed B
Member
2012-Dec-6 12:47 pm
Great, thank you for the info. |
actions · 2012-Dec-6 12:47 pm · (locked) |
BHNtechXpertThe One & Only Premium Member join:2006-02-16 Saint Petersburg, FL |
to Ed B
Russound IR-Remod may help this solution. Powered unit, takes ir in at 40k and remodulates to 56k through a single output. Solves lots of problems.
214836 Russound IRREMOD IRREMOD - 56KHZ ADAPTER $15.98
This is his units spec below. Allows for IR Control over any HDMI Cable To Connect add an HDMI IR Adapter to both ends of the HDMI Cable IR TX Pigtail connects to HDMI IR adapter at the source IR RX Pigtail connects to HDMI IR adapter at the display Extends IR Signals more than 100m/328 ft Supports IR control in the 38 KHz mode HDMI IR Adapters are IR or CEC configurable |
actions · 2012-Dec-6 2:11 pm · (locked) |
BHNtechXpert |
to Ed B
So which way did you go with this? |
actions · 2012-Dec-8 9:04 pm · (locked) |