|
to conitssap
Re: [Voip.ms] Cant answer incoming callsMaybe it's the phone handset? Have you tried a different one plugged directly into the ATA? |
|
|
Sometimes you overlook the obvious Im using a Panasonic cordless phone. I will try it with a standard wired handset and see if that helps. |
|
conitssap |
to Springbok
didnt work with a direct line plugged in - it actually got worse - took me 10 tries to get an answer while the cordless would take 2-3. changed the phone cord and that did not help either. not sure why it would get worse though - changed impedance and Ren setting but that did not make a difference. |
|
|
Here's my ATA settings with voip.ms and although I dont use the analog phones much these days, it's always working when I try them:
PAP2T Firmware Version: 5.1.6(LS) NAT Keep Alive Intvl: 15 seconds Ring Waveform: Sinusoid Ring Voltage: 90 Ring Frequency: 20 Register Expires: 60
I also remember being advised to use the hard IP address of my voip.ms POP and not the DNS name on this ATA (dont remember the reason). |
|