|reply to Hookem59 |
Re: Multiple unsuccessful attempts at connecting WNDR4500 to ONT
If you dont want to wait the 2 hours for the DHCP lease to expire, pull the battery connection from the ONT and then pull the power plug for about a minute and plug it back in.
I tried pulling the power on my ONT to test if it would release
the IP when I was attempting to swap in my own router.
Didn't matter, the only way I could get the IP to the new
router was to release it on the old ActionTech. That always
seemed to work for me. My other/new router had no problem
then getting an IP with a direct Ethernet connection.
Seems to me that the IP is tied to the "magic" address
of the ONT, not the router. Whether I cloned my MAC or
not on the new router, I always get the same IP. And
as I said, pulling the power on the ONT made no difference.
It's all tied back to the CO and the ONT - which is the
way it seems.
If somebody can confirm this is how it works, please say
so, but that's the way it appeared. Doesn't make sense
why doing what you did with the release, didn't work
No speed negotiation on the router (that makes no sense),
but have to set it to Auto DHCP. And have to release it
from the old router.
You have to kill the ONT completely by also unplugging the backup battery (it's behind a customer accessible door).
Not on mine. I have a SOHO ONT where the battery and
power supply are integrated together in a separate
and very large external box (it has 4 batteries).
When I pull the power connector plug from the
ONT it's 100% disconnected.
The regular home ONT, you are correct, that is the case.
There is no reset button on the SOHO ONT, you have
no choise but to pull the power plug.
|reply to Uncomm0n |
I did try that (unplugging the power cord and one of the battery leads), but that didn't work. Still had to call the FSC for a reset.