dslreports logo
site
 
    All Forums Hot Topics Gallery
spc

spacer




how-to block ads


Search Topic:
uniqs
12
share rss forum feed


Wily_One
Premium
join:2002-11-24
San Jose, CA
Reviews:
·AT&T U-Verse
reply to mackey

Re: WiFi signal Strength

said by mackey:

2) Before hooking it up to the 2wire, log in to the admin interface (on the new router) and disable the DHCP server and make sure its IP address is different then the 2wires'.

Then my wired machines won't work unless I give them static addresses. The way around that would be to simply create a separate DHCP range on the WiFi AP but within the same 192.168.1 subnet as the RG.

Now I'll have to look into a good but cheap Wireless router.


mackey
Premium
join:2007-08-20
kudos:12
said by Wily_One:

said by mackey:

2) Before hooking it up to the 2wire, log in to the admin interface (on the new router) and disable the DHCP server and make sure its IP address is different then the 2wires'.

Then my wired machines won't work unless I give them static addresses. The way around that would be to simply create a separate DHCP range on the WiFi AP but within the same 192.168.1 subnet as the RG.

Now I'll have to look into a good but cheap Wireless router.

What are you talking about? Step 3 causes everything behind the new router to get an IP from the DHCP server on the original router. I said LAN port to LAN port, not LAN port to WAN port.

/M


Wily_One
Premium
join:2002-11-24
San Jose, CA
Reviews:
·AT&T U-Verse
What I have hard-wired will remain as it now, plugged into the RG. I took your post to mean plugging everything into this new router, which would be down-level from the RG.

Are you saying the RG will pass DHCP requests from machines hard-wired to it on to this other router?


mackey
Premium
join:2007-08-20
kudos:12
When connected LAN to LAN, everything is on the same network/level (they're both equal; one's not "down-level" from the other). This is why you need to disable the DHCP server on the new router. Everything connected to the new router, both wired and wireless, will simply be passed along to the existing RG.

The WAN port on the new router should be left not connected to anything.

With the DHCP server disabled and nothing connected to the WAN port, the new "router" is now nothing more then a dumb switch and wireless access point.

/M


Wily_One
Premium
join:2002-11-24
San Jose, CA
Yeah see I was thinking of mounting an AP up high, so don't want all but one network cable attached.