dslreports logo
site
 
    All Forums Hot Topics Gallery
spc

spacer




how-to block ads


Search Topic:
uniqs
31
share rss forum feed


ITALIAN926

join:2003-08-16
kudos:2
Reviews:
·Verizon FiOS
reply to rocks911

Re: The RG6 Compression fitting blues

Why would Verizon install an unnecessary
"bigger splitter" in order to introduce more signal loss?

Nobody can give you any perfect advice here, there is signal loss with amount of splits, and length of coax.

Forget that Dynex. If youre adding just one outlet, pull off the current shortest coax run from 6way and put that on the 2way along with your new run.

Hopefully theres nothing wrong with your 2way splitter, verizon would know if a splitter is defective in 60 seconds. You will have to figure it out over time with TV usage. Scroll through your channels , and test on-demand.


rocks911

join:2012-06-05
Garland, TX

Thanks for the advice on the Dynex splitter Italian, I have a splitter coming from verizon, I'll just wait for it to be delivered.

You asked "Why would Verizon install an unnecessary
"bigger splitter" in order to introduce more signal loss?"

I have a 5 bedroom home with 2 living rooms and a mancave, the reason seems obvious why I would want Verizon to have installed a splitter sufficient to cover my entire house. Is it unreasonable to expect that maybe 8 drops be connected in a 3500 Sq. Ft. house?


kes601

join:2007-04-14
Virginia Beach, VA
kudos:2

If there was not tv or a router in the rooms when FiOS was installed then the installer would have had no reason to install a bigger splitter and as was stated, the more splits, the bigger the signal loss.



ITALIAN926

join:2003-08-16
kudos:2
Reviews:
·Verizon FiOS
reply to rocks911

A very long run connected to an 8 way, opposed to a 6 can put the signal just beyond an acceptable low point. Again, depends on length of coax. You dont have to wait for the VZ splitter, even a new splitter can be defective. If the Regal is marked 5-1000 mhz, it should be adequate. Like I said, if any of the runs are SHORT, put them onto the 2way out of the 6.

Good luck.


blue_trooper

join:2007-04-17
Exton, PA
reply to kes601

said by kes601:

If there was not tv or a router in the rooms when FiOS was installed then the installer would have had no reason to install a bigger splitter and as was stated, the more splits, the bigger the signal loss.

I know it varies by ONT but when I got mine installed (2006) the signal out of the ONT was so strong they put attenuators on the line. The same result could be managed by using a 'too big' splitter.


PoloDude
Premium,VIP
join:2006-03-29
Northport, NY
kudos:3

said by blue_trooper:

said by kes601:

If there was not tv or a router in the rooms when FiOS was installed then the installer would have had no reason to install a bigger splitter and as was stated, the more splits, the bigger the signal loss.

I know it varies by ONT but when I got mine installed (2006) the signal out of the ONT was so strong they put attenuators on the line. The same result could be managed by using a 'too big' splitter.

Attenuators were used when VZ was supplying an analog signal. That has not been the case for several years now.
--
“My horse fights with me and fasts with me because if he is to carry me into battle, he must know my heart and I must know his or we shall never become brothers.
-Plenty Coups, Chief of the Crow”


aaronwt
Premium
join:2004-11-07
Woodbridge, VA
reply to ITALIAN926

said by ITALIAN926:

Why would Verizon install an unnecessary
"bigger splitter" in order to introduce more signal loss?

...............

In my initial installation they installed an eight-way splitter even though I only needed it in three locations. The signal from the ONT is very hot which is why he put the eight-way splitter in. I can split the signal several more times after that eight way splitter and still have no issues.

kes601

join:2007-04-14
Virginia Beach, VA
kudos:2
reply to PoloDude

Ahh, didn't know it was due to the analog signal. Good to know.



ITALIAN926

join:2003-08-16
kudos:2
Reviews:
·Verizon FiOS

2 edits
reply to aaronwt

LOL Go ahead split it "several more times" after that 8 way.

You want to start with 11-12db on an 8, then add SEVERAL more after that. Lets be generous and assume youre talking about "several" 2 way splitters with 3.5 to 4 dB loss on each port. How many is "several" ? Lets just say 2. 12dB + 8 dB is ~20dB of loss. I HOPE all your TV's are in arms length to the ONT, because we must consider about 6dB /100 feet of rg6 coax. Shall we even mention how temperature can negatively affect these numbers as well?

FYI, depending on distance, adding ANY splitters after an 8 puts the signal BELOW what Verizon rates as acceptable, and is a recipe for pixilation and/or missing channels.