|reply to bdmhenderson |
Re: Netgear FVS124G
When setting up a pair of Watchguard boxes to do a site-to-site VPN, there is no "which dials which". Each end is set to search out the other at a specific IP (or FQDN if you have dymanic IP's). They find each other and connect just a few seconds after booting up.
I eventually got the VPN going had to end up using Fully Qualified User Name before it would work.
I have also got a netgear FVS318 - however if use the same settings for this the VPN doesn't work, it shows connected on both ends however I can't ping machines across the VPN - any thoughts on this?
Seen a couple of posts elsewhere with the same problem however they never mentioned if the found a solution (The posts were a couple of years old!)