| reply to Anav
Re: Interface status.....From the CLI, try the following :
config t
int [the specific int]
shut
no shut
^z
That'll reset the port, but I'm really not sure if there's a GUI equivalent in ADSM. You might also want to
try a "show int [the specific int]" from the CLI. If both the int and line protocol are in DOWN state, likely
nothing connected, or someone was waltzing in the datacenter again and tripped over a cable.
3750G#sh int gi 1/0/2
GigabitEthernet1/0/2 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet, address is ...
BTW, weren't you making noises about kicking this ASA to the curb for a Zyxel, or am I remembering incorrectly Anav?
Regards |
 AnavSarcastic Llama? Naw, Just AcerbicPremium
join:2001-07-16
Dartmouth, NS
kudos:3 | Only because I had no choice amigo. If I could use personal equipment vice authorized work equipment, it would be in a dump pile with vaccum cleaners from the 50s. Seriously, its way to complex (albeit flexible) for most applications. |
