AnavSarcastic Llama? Naw, Just AcerbicPremium
Intra Zone Traffic Blocking.
I noted default on WAN was yes for intra zone blocking (on my usg300). In my actual setup USG100, I have it set to no.
On my Wan zone, I have wan1 (isp provider eastlink) on wan2 (isp provider Bell) and I have VLAN35 which rides through Wan2 (gets DHCP etc).
Now Is there any harm to setting Wan intra block YES (on). I was concerned that perhaps VLAN35 being blocked from WAN2 was possible as they are distinct entries in the table????
Ain't nuthin but the blues! "Albert Collins".
Leave your troubles at the door! "Pepe Peregil" De Sevilla. Just Don't Wifi without WPA, "Yul Brenner"
Doesn't this setting only keep the ISPs from communicating with each other via your router? In a corporation with arrays of routers, a router could be the shortest hop length between two other routers and this switch might be used to disable that path. Otherwise, I readily admit to not understanding its purpose.