dslreports logo
 
    All Forums Hot Topics Gallery
spc
uniqs
30
Nano_Magnus
join:2011-10-19

Nano_Magnus

Member

Re: Help with Cisco 1921 - not booting

Ok, I found my license File and the IOS and a backup of my runnig configuration, but I can't copy anything to Flash0: so I copied everithing to Usbflash0:

And when I configure Http acces using telnet it works until I shutdown the router, and when I startup the router again there is no Http acces again and all the configuration back to 0

I'm not sure what to do, so i need help.

Thanks
cramer
Premium Member
join:2007-04-10
Raleigh, NC

cramer

Premium Member

a) save the config (wr mem)
b) set the conf-reg to actually load the startup config

"A" you may be doing already. "B" may be necessary if anyone has half-way "recovered" the device.
HELLFIRE
MVM
join:2009-11-25

HELLFIRE

MVM

2nd what cramer See Profile has said.

Definately keep a copy of said IOS and licence in a place you can find it in case this happens again.

Regards
bigsy
join:2001-07-18
ireland

bigsy to Nano_Magnus

Member

to Nano_Magnus
said by Nano_Magnus:

Ok, I found my license File and the IOS and a backup of my runnig configuration, but I can't copy anything to Flash0: so I copied everithing to Usbflash0:

usbflash0: and flash: are the same. Note that it is not flash0: