US Telco Support → CenturyLink > Setting up two Q1000 routers together via wifi?

Setting up two Q1000 routers together via wifi?

Hello,

I've got some wifi signal problems in my home. I currently have two Q1000 routers from century-link. What I would LIKE to do is use one of the routers as a wifi extension. Like a repeater. Unfortunately I've had no luck figuring out how to do this via searching the web. So, is this possible to do? If not, is their another alternative other than moving the router or pc. They pretty much need to stay where they are now and running a wire through the house wouldn't be plausible.

Thanks in advance!

Chris

I don't think you can use a Q1000 as a wireless Access Point.

Have you looked at Wireless Access Points? You connect it to your router (via Ethernet) initially to setup the wireless & then move it to the position you want it.

You need either another access point or a wireless router configured to work as an access point. If running a cable to the necessary location is not possible, then try powerline adapters. If powerline adapters don't work, use a wireless gaming adapter to feed the access point.

Another option is a dual-radio repeater (essentially a wireless gaming adapter and access point in one box). Don't bother with a single-radio repeater, the throughput will be very poor.

At my buddy's house in Scottsdale, we ended up getting a C2000A, using HPNA to go to the other end of the house where we just installed a standard ASUS router, the setup came to less than $100 on eBay and works like a charm.

Essentially, he's set up like DSL -> C2000A -> HPNA over Coax adapter -> 2nd WiFi router in bridge mode so the C2000A handles all of the IP addressing so everyone is on the "same" network.

Well, I noticed there is a WDS option on the router. From what I understand WDS mode should be able to get me the desired results. However, the issue I don't understand is how to get the two routers to actually connect in some way.

Ok, I took a look at the power-line adapter idea you mentioned. It actually looks highly viable as an option for me. Has anyone set up a router to another router using a power-line adapter successfully? I have two computers I need networked downstairs so I'd still prefer to have that second router. I should be able to put up a transparent bridge up on the 2nd easy enough if it's wired through this method correct?

The second router should have DHCP turned off, and have a LAN address (in the same subnet) that does not conflict with the first router (use .1 on first router and .2 on second router). Connect a LAN port on the first router to a LAN port (not WAN port) on the second router. Set the SSID and security the same on both units.

The powerline adapters are used in place of running an ethernet cable between the routers. If unused coax is available, you could also use DECA or MOCA adapters to complete the connection. The only drawback to powerline adapters is they don't work in every house. You may have to experiment with different outlets to get a good connection. Do not plug them into a power strip, and do not have wall-warts (cell phone charger, etc.) connected to the same outlet.

I went out and purchased some AC line adapters and I must say, the results are superb! The 2nd router is close enough to have both computers wired to the router and speeds are maxed. Thanks so much for your help! I'm browsing the internet like a boss now.