USG 100: Block User-to-User Traffic on Same Subnet
I'm not sure this is possible (since I don't believe the traffic even makes it to the router interface), however I'm hoping someone has some ideas:
I have a VLAN setup for guest users - both WLAN and LAN. My wireless AP's allow for "guest mode isolation", where users can only see the Internet and not each other (even though they are on the same subnet).
Is there any way to easily set this up for the LAN users?
OK - thanks for the quick reply. I know this is a little out of the scope of the Zyxel forum - but can this be done with a Procurve 1810 or similar (Layer 2 switch)? Looks like I need the "Private VLAN" in Cisco-speak. Thanks again.