Hello,
I'm a new Start client, and although when I ordered the service I inquired about IPv6 and was told it's not supported I was happy to find that it is.
I have a couple of questions though. I had a DD-WRT router that seems to have died on me (I haven't had the chance to check what happened to it yet) and with that one I was using a Tunnelbroker IPv6 setup (this before I found this post)
Anyway after it died I had to use an Airport Extreme as a router and was surprised to see that it automatically setup a 6to4 Tunnel.
I tried to get it to work with the 6rd information from this post but I'm missing an IPv6 Default Route to put in there, when following the instructions here (»
pastebin.com/0HRTSxqV) it doesn't work. I'm using 7.6.4 Firmware Version.
Now on to my questions:
1 - Is it possible to have a statically assigned IPv6 address ?
Seems every time I get a new PPPoE connection I also get a new IPv6 prefix.
2 - Do you have any suggestions on how to get 6rd working with the Airport Extreme ?
I'm not sure if there are many advantages over the automatic 6to4 tunnel though.
3- Any plans for full native IPv6 support ?
Thanks