|reply to roberthalton |
Re: plugging linksys into my 678 how to?
If your 678 is set to dhcp you need to call Cyberonic and have them set it to static ip/bridge mode then everything should be ok.
actions · 2003-Feb-4 7:12 pm · (locked)
Anyone have instructions on how to set it to static?
I have all the required passwords etc..
actions · 2003-Feb-5 11:35 am · (locked)
BritSys support posted this - »Cisco 678 config - Change NAT to routed.
Instead of starting from scratch, this might be ok though:
set dhcp server disabled
set nat disabled
set interface eth0 ip (gateway) mask 255.255.255.252
reboot[text was edited by author 2003-02-05 12:12:09]
actions · 2003-Feb-5 11:59 am · (locked)