| reply to chipd
Re: New Firmware - Built in TX mW selection UPGRAD said by chipd:
What does the 10Mbps/half duplex do?
It slows the network card down to 10Mbps and switch to half duplex (ie one way communication at a time).
Not sure if it's 100% required, but I always like to do it before flashing firmware. |
|
chipd
join:2004-01-02
Philadelphia, PA | reply to digiblur
Re: New WRT54G Firmware - Built in TX mW selection What do the TX antenna and RX antenna options do? How do we know which one is better? Right, Diversity, Left? |
|
| They are for using an external antenna. If you are using the stock antennas then Auto is the best setting.
If you replace of the stock antennas with a more powerful external antenna you can force its use by setting the txant and rxant commands. |
|
|
|
chipd
join:2004-01-02
Philadelphia, PA | Thanks! That makes sense. I imagine by Auto you mean Diversity since there are only 3 options (Right, Diversity, Left) and Diversity is listed as the default. |
|
| I think you must be using the Wifibox or some other firmware. On mine they are labled "Left", "Right", "Auto". I'm sure the behavior is the same as it's a simple modification that just reflects an internal command state outwards. |
|
chipd
join:2004-01-02
Philadelphia, PA | Sveasoft you are correct. I am actually using wifibox at the moment. I see what you mean. Thanks for the assistance. |
|
