Re: New WRT54G Firmware - Built in TX mW selection!
WPA is, for the most part, unusable on my setup. I was able to get it to work for maybe 5 seconds, once. Not sure what the nature of the problem is. I had to fallback to wep (yuck!) for now. WPA was working fine with the previous firmware I was using. -- Join BroadbandReports.com's SETI@Home Team Put your unused clock cycles to work!
To all it may concern: I have a wrt54g with 1.42.2 (1.42.3 samething) firmware in it and it to has trouble keeping correct time.I have contacted Linksys many times about it, they told me I had a bad units. I am now on my 3rd unit same problem. When I talked to linksys they acted as if they never heard about this problem existing. The last time I talked to them they tried to say it was my ISP or my cable modem causing the problem. I believe 1.30.7 firmware had the NPT timeserver available on the setup page but on later releases taken off. Maybe Linksys needs to hear more about this problem.
Re: New WRT54G Firmware - Built in TX mW selection
I also have noticed the time problem with 1.4.2x firmware. I am running 2.008 today and so far the router time has not changed. The router gets the time from the dhcp server and if it was correct in previous versions it should work on 2.008.
·