dslreports logo
site
 
    All Forums Hot Topics Gallery
spc

spacer




how-to block ads


Search Topic:
uniqs
11
share rss forum feed

The Chef

join:2003-12-09
reply to starstuff

Re: Speedstream 5100b hardware configuration

said by starstuff:

This way you can access the GUI or the SNMP ( if the B model supports it )

I do not think the unit supports SNMP.


starstuff
Fly By Wire
Premium
join:2001-12-05
Mcallen, TX

said by The Chef:

I do not think the unit supports SNMP.

Too bad... version A does.
--
Observation, hypothesis, prediction, experimentation, conclusion... The scientific method.


Doctor Olds
I Need A Remedy For What's Ailing Me.
Premium,VIP
join:2001-04-19
1970 442 W30
kudos:18
reply to The Chef

said by The Chef:
I do not think the unit supports SNMP.

All Efficient products (Modem, Modem/Routers, etc.) support SNMP that I've seen.

I do not know about their Speedstream standalone brand though (the Routers that do not have integral ADSL Modems at »www.speedstream.com/ )

Regards,

Doctor Olds


pflog
Bueller? Bueller?
Premium,MVM
join:2001-09-01
El Dorado Hills, CA
kudos:3

The 5100b doesn't seem to support snmp (at least when in bridged mode):

nmap -vvv -S 192.168.0.2 -e eth0:1 -P0 -sU -p 161-162 192.168.0.1

Starting nmap 3.50 ( »www.insecure.org/nmap/ ) at 2004-02-25 22:39 PST
Host 192.168.0.1 appears to be up ... good.
Initiating UDP Scan against 192.168.0.1 at 22:39
The UDP Scan took 1 second to scan 2 ports.
Interesting ports on 192.168.0.1:
PORT STATE SERVICE
161/udp closed snmp
162/udp closed snmptrap

Nmap run completed -- 1 IP address (1 host up) scanned in 0.578 seconds
--
"I drank what?" -Socrates



Doctor Olds
I Need A Remedy For What's Ailing Me.
Premium,VIP
join:2001-04-19
1970 442 W30
kudos:18

1 edit

That's from the WAN side, right? (that should not normally respond for security reasons). Have you tried from the LAN side?

It also been mentioned that XML is used instead.

Regards,

Doctor Olds



pflog
Bueller? Bueller?
Premium,MVM
join:2001-09-01
El Dorado Hills, CA
kudos:3

No, this is from the LAN side (hence -S 192.168.0.2 which is what eth0:1 is assigned

Well, for now I'm able to get away with some perl scripting using Net::HTTP to get the statistics.htm page and parse out the attenuation and SNR which is working ok so far. It'd be nice to use SNMP directly, though
--
"I drank what?" -Socrates


we9850

join:2004-03-23
Adkins, TX

what does the attn dl rate 192 mean????