digixmax
join:2004-02-11
usa
| reply to digixmax
Re: using WRT54G as a bridge to another WRT54G
I just want to report that I am finally able to get my WRT54G in client mode to work with my BEFW11S4. The client WRT is setup based on the guide »homepage.ntlworld.com/linksysinf···UIDE.pdf. The problem I had appears to be due to the use of wireless MAC filtering on the BEFW11S4. For some reason, even adding the MAC addresses of the client WRT and the attached PC to the filter list did not work, but disabling the wireless MAC filtering entirely and then power-cycling the BEFW11S4 did it. |
|
digixmax
join:2004-02-11
usa
| reply to pzero
I'm been trying to get my new WRT54G running Satori-4.0 to be a client to my old BEFW11S4 without much success. I was able to ping the BEFW11S4 from a PC which is wired to the WRT54G for just a short period of a minute or so during the course of hours of fiddling.
Can someone who has succedeed in using a WRT54G client with another non-WRT54G wireless router post the client setup configuration and procedure?
Thanks. |
|
pzero
join:2004-10-11
Italy
| reply to grcore
said by grcore  :with Satori in client mode, only 1 device is allowed to be connected that unit. If you add more it won't work properly. This is a big limitation IMHO, any workaround for it?
The client mode of Samahdi and Satori are pretty much the same, Alchemy does thing differently. With Alchemy, the wireless interface becomes the WAN interface of the router. This allows multiple clients to be connected to the client mode WRT (on their own subnet). This sounds interesting. Will I still be able to use two WRT54G/WRT54GS boxes to create an ethernet (wifi) bridge between two LANs using the same network (e.g. 192.168.0.1/255.255.255.0) on both sides of the bridge.
Any ETA about the Alchemy public release?
Thanks a lot. |
|
grcore
New and Improved
join:2003-12-06
usa
| reply to prestonlewis
said by prestonlewis :
Yes, all 4 LAN ports work fine in bridge (client) mode. You can add a switch to one of the ports to have even more ports available. I've done that without problems. As for your 2nd question, a WRT54G in client (bridge) mode doesn't care what access point it is using. It just needs to have ssid, channel, encryption, etc. set to match. I don't think it matters which version of firmware you are using. As far as I know, Samahdi, Satori, and Alchemy all work the same when it comes to bridging and the brand of access point used isn't an issue.
with Satori in client mode, only 1 device is allowed to be connected that unit. If you add more it won't work properly.
The client mode of Samahdi and Satori are pretty much the same, Alchemy does thing differently. With Alchemy, the wireless interface becomes the WAN interface of the router. This allows multiple clients to be connected to the client mode WRT (on their own subnet).
When you set a WRT to client mode it loses its ability to be an AP, so devices cannot connect to it via wireless (all devices must be wired to it).
G |
|
