funchords
Hello
Premium,MVM
join:2001-03-11
Washington, DC
 ·Verizon Online DSL
 ·Skype
| reply to Scree
Re: [Util] "DI-604 Connection Monitor" utility
I think they're probably the same, but just in case... |
|
Scree
In the pipe 5 by 5
join:2001-04-24
Mount Laurel, NJ
 ·Comcast
1 edit | Interesting, the 624 text appears the same except it is missing the "total entries =" line. So, the only issue would be the "Show Only Found" setting since that edits the second line, meaning it would show your data missing the 0) line in this case. I'll see what I can do to support that right. |
|
funchords
Hello
Premium,MVM
join:2001-03-11
Washington, DC
·Verizon Online DSL
·Skype
| said by Scree  :Interesting, the 624 text appears the same except it is missing the "total entries =" line. So, the only issue would be the "Show Only Found" setting since that edits the second line, meaning it would show your data missing the 0) line in this case. I'll see what I can do to support that right. Just to confirm that it was not a cut-and-paste error on my part. I just checked the router again and there is no "Total" mentioned.
However, I am using firmware 2.42. Someone with firmware 2.50 and 2.52 should also check »(your router ip)/NATLIST.TXT and see if the word "total" is mentioned anywhere.
--
Robb Topolski
http://www.funchords.com/
Hillsboro, Oregon USA |
|
Tsume
join:2004-02-23
Johnson City, TN | Here is the first lines of my 624! FW 2.52, the one with WPA2:
quote:
curr time : 916312
total entries = 299
0)
|
|
Tsume
join:2004-02-23
Johnson City, TN
·ViaTalk
·Comcast
·Cox HSI
| 
It works on the 624! |
Do you think you could make it not connect when you first start it up, to give me time to change the IP before it tries to connect? The program was frozen for 15-30 seconds while it tried to connect to the default address, which isn't my router. Just a minor issue, after it said connection failed I changed the address and now it works =] |
|
Rooki
join:2004-10-02 | reply to funchords
Hi.
I have tested this program on D-Link 624+ (v1.21)
and it works.
I can see total entries, but Show Only Found must
be disabled.
TNX....
Regards. |
|
Tsume
join:2004-02-23
Johnson City, TN | That's the way it's supposed to work I think.
It replaces the 2nd line [which should be total entries, and the problem is on 2.42 it will replace line 0 since there is no total entries] with the showing only found text. |
|
