too2buff
join:2003-03-23
Maplewood, NJ
| [Wireless] wrt54g not connecting running alchemypre7a
Purchased a WRT54g v3 running the most recent linksys software hooked up my modem upstairs
I then used my WRT54G v2 w/ Alchemy pre7a firmware on it and put it in my basement
v2
address is 192.168.1.2
subnet - 255.255.255.0
gateway 192.168.1.1
Wireless setup - disabled
DCHP - disabled
firewall - disabled
WEP - enabled (key is correct)
and broadcasting SSID enabled
I wired this item to the PC and set it up with an IP , Subnet and a router gateway of my router 192.168.1.1
I tried it in client mode and in AP mode nothing will connect
where do I troubleshoot ?
what am I doing wrong?
thx |
|
Da Geek Kid
join:2003-10-11
Mclean, VA | Re: [Wireless] wrt54g not connecting running alche
HUH? what AP? what Client mode?
you state no DHCP and no wireless... what are trying to achieve? |
|
too2buff
join:2003-03-23
Maplewood, NJ
| sorry i'm trying to use WRT54g in bridge mode. I have the router upstairs connected to 3 computers then two floors down I need to connect 3 more computers. I used to use the LInksys wet11 bridge but that is now hard to find and slow compared to buying another router and using it in Bridge mode (WRT54g w/ different firmware). I used another firmware alchemy pre7a
but after installing everything I cannot connect it to my other router
I just need to know how to troubleshoot this problem or what do i have configured incorrectly sorry for being sooooo vage |
|
Da Geek Kid
join:2003-10-11
Mclean, VA
| reply to too2buff
now that's a lil better but still need more info...
Tell us all about yer lil network. What router is used? if there are any switches? are there any extra long cables runnin around on the network? please, Esssssssssssplain moe...  |
|
