Re: 2610 Cisco / WIC 1ENET Issues

Forums » Equipment Support » Hardware By Brand » Cisco » 2610 Cisco / WIC 1ENET Issues


Share Topic:	RSS topic:	toggle: flat / full normal / watch	Posting:	Post a:	Post a:

Links: ·Submit a new forum topic ·Forum FAQ ·Submit a FAQ ·Docs Guidelines and Advisories ·EOS/EOL thread

T1 connection »
« Problems with Pix 506e configuration

bigdogg2

join:2004-08-11

Re: 2610 Cisco / WIC 1ENET Issues

Thanks for the link! I guess I will try to sell my serial card and then buy one with an ethernet port:\

I do have a Cisco 806 router loaded with the newest IOS that I'm currently using. I wanted the 2610 so I can create vlans with my dell switch atleast this is the method behind my madness! The current modem I'm using is Paradyne and I have a crossover cable going over to my 806 router/firewall. So this does not have a serial interface:( So I guess I'm stuck buying a ethernet card for the router. Any more suggestions would be great!

permalink · 2005-09-13 08:19:54 · Print ·

aryoba
Premium,MVM
join:2002-08-22

Re: 2610 Cisco / WIC 1ENET Issues

If you wish, you can use the onboard Ethernet 0/0 port of the 2610 to do inter-VLAN routing and trunking. Yes, a 10 MBps interface of a router can do inter-VLAN routing and trunking (with some limitation of course).

I have a 2610 run IOS image of IP FW/VPN/3DES/IDS PLUS version 12.3.12a that is currently setup for inter-VLAN routing and trunking with dot1q encapsulation, using the onboard Ethernet 0/0 port.

However if you still wish to get another Ethernet module for the 2610, get NM-1FE-TX. You should be able to find one from ebay.

permalink · 2005-09-13 09:39:39 · Print ·

your comment..

Forums » Equipment Support » Hardware By Brand » Cisco	T1 connection » « Problems with Pix 506e configuration


Saturday, 28-Nov 17:33:39	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com.republican-creole page compression OFF