hardly
join:2004-02-10
USA | reply to mazilo
Re: [PAP2] Unlocking Guide
Once unlocked, can you flash with Linksys PAP-2NA firmware?
If so, can you then perform a Factory Reset without worrying about it reverting to Vonage defaults?
Thanks |
|
rizzo2dial
Premium
join:2004-08-05
| The PAP2 and PAP2-NA use identical firmware. The PAP2 has different NVRAM values burned into the device than the PAP2-NA which is why a Master Reset reverts the device back to a locked Vonage adapter.
I tried numerous combinations of trying to reset the adapter (both while in "Sipura" mode and "Linksys" mode, switching back 'n forth between the firmware flavors).
It "Sipura" mode, a master reset acted like all "default Sipura" settings were loaded; however, once switching back to "Linksys" firmware, it was a locked PAP2 Vonage adapter again.
Rizzo |
|
mazilo
From Mazilo
Premium
join:2002-05-30
Lilburn, GA
| reply to hardly
said by hardly  :Once unlocked, can you flash with Linksys PAP-2NA firmware? PAP2 and PAP2-NA firmware are 100% identical.
If so, can you then perform a Factory Reset without worrying about it reverting to Vonage defaults?
Thanks Once unlocked and factory reset, the PAP2 will be locked again. |
|
hardly
join:2004-02-10
USA
| reply to rizzo2dial
Is there a modified Sipura firmware available that will load using the PAP2 web interface from a file located on a local machine?
Would that effectively turn this device into a SPA2000 (or SPA2002), then only needing to update firmware as if it were a Sipura and not dealing with it reverting to a locked Vonage device?
PM me if you need to.
Thanks
said by rizzo2dial :The PAP2 and PAP2-NA use identical firmware. The PAP2 has different NVRAM values burned into the device than the PAP2-NA which is why a Master Reset reverts the device back to a locked Vonage adapter. I tried numerous combinations of trying to reset the adapter (both while in "Sipura" mode and "Linksys" mode, switching back 'n forth between the firmware flavors). It "Sipura" mode, a master reset acted like all "default Sipura" settings were loaded; however, once switching back to "Linksys" firmware, it was a locked PAP2 Vonage adapter again. Rizzo |
|
exousia1
join:2005-10-09
Anaheim, CA
| reply to mazilo
I want to get my PAP2 back to Linksys PAP-2 firmware. I tried to unlock it. Right now the admin page shows Sipura. Will a factory reset do this or do I need to reload the firmware? Where can I get that firmware? How do I actually do a factory reset? Any help you can give me will be greatly appreciated. Thank you! |
|
