said by Enlightener :

This is a problem that would be solved with a pocket knife and a screw driver faster then talking about it here.

Cut the dang cable. Strip the red and green leads and connect it to an RJ-11 jack. Pick a jack that can be surface mounted if it's coming out by a baseboard or pick a jack that is recess mounted if it's coming out of the wall. Mount the jack on the wall, throw the old rotary phone away and get a modern telephone. Otherwise splice an RJ-11 jack on the old cable to the phone if you still want to use it.

This isn't rocket science. I was solving problems like this in old houses over 25 years ago when I was 7 years old.

said by satasi :

Ok, does the wall phone have a modular jack on the back of it? SATASI

said by Mountaineer1 :

So it a rotory phone,with a wire coming out the back of it,with a RJ-11 male connector at the end onf the wire?

Edit: You need a wall mount DSL filter?

said by sonic2000 :

the rotary phone again has no connectors at the end. It goes straight into a jack, i guess it's a modular one I am not a pots person so i don't know.

said by satasi :

Can you post a picture of the wall phone and jack? SATASI

said by satasi :

Like I said earlier it is hardwired in the phone set, if you take the cover off the wall phone you should see the IW wired to terminals T,R,G which is TIP, Ring and ground. SATASI

said by satasi :

First, you have to get a modular rj11, second, you have to make a short modular cable on one end and open face on the other end so you can hardwire the open face end into the phone....once all that is done just put your filter in the modular jack and plug the cable you made for the phone in the phone side of the filter. SATASI

said by satasi :

Yes sir....SATASI