gizmogameboy
join:2006-06-05
Vancouver, BC
| reply to gizmogameboy
Re: [PAP2] Unlocking Guide -
My PAP2-NA was supplied to me unlocked by my VoSP with firmware version 2.0.13. I just upgraded to version 3.1.10(LS)
I've tried dialing **** to get to the IVR but the PAP2-NA seems to reboot itself when I do that. Anyone else notice this happening to their PAP2 / PAP2-NA? |
|
meister_sd
Premium
join:2006-01-29
La Mesa, CA
| said by gizmogameboy  :Anyone else notice this happening to their PAP2 / PAP2-NA? Not me. I have that on one of mine... You can get an official release from linksys that is 3.1.12, but I haven't tried this one myself. |
|
supercool
join:2005-02-08
Plano, TX | Help
I loaded a Sipura 2.0.9 firmware on a pap2 3.1.9 LSc (von) but my web interface is not enabled. I tried the IVR 7932 option but I do not know the password. Please any suggestions .
Thanks |
|
mazilo
From Mazilo
Premium
join:2002-05-30
Lilburn, GA
| said by supercool :I loaded a Sipura 2.0.9 firmware on a pap2 3.1.9 LSc (von) but my web interface is not enabled. I tried the IVR 7932 option but I do not know the password. Please any suggestions . If you can try to first factory reset your PAP2 on an isolated LAN, this will definitely re-enable the web interface. Or, you can feed your PAP2 with a simplified and plain-text XML file that will enable web interface. The later approach has been discussed here numerously. Please take your time to read posts in this thread. You are not only going to find out your answer, but you will also learn a lot of the DOs and DON'Ts regarding your unlocked PAP2 unit!
--
Mazi (UK Non-Geo Phone: +44-703-194-2574) |
|
gizmogameboy
join:2006-06-05
Vancouver, BC
| reply to gizmogameboy
said by gizmogameboy :I've tried dialing **** to get to the IVR but the PAP2-NA seems to reboot itself when I do that. FWIW, found out that changing the codecs and saving settings seems to restore the IVR.(maybe just making any change and saving the new settings will work too).
- If I then power down the unit and restart it I lose the IVR again.
- If I dial **** from line 2 (which is the line I did not make codec changes) the unit reboots.
Not sure what is happening here |
|
