how-to block ads
|
Diddy1
join:2003-07-19
Sidney, NE
| Re: Watertown Mount Well, do you guys remember the CB radio days? There were a plethora of magnet mounted antennas that went directly on the vehicle and were several feet tall! So, there is something to the magnet thing. Funny how I forget past innovative solutions  The magenet idea sounds very realistic after that. I thought robbin was joking but obviously he is a great deal more enlightened than me on the subject. I wasn't trying to insult robbin 
Aaron | |
|  robbin
Premium,MVM
join:2000-09-21
Leander, TX
1 edit | Re: Watertown Mount Thanks, I didn't get insulted.  I did a search of this forum for water tower magnets and found this old thread. Searches using water tower mount turn up reasons not to drill or weld. Epoxy may be an option but I would be hesitant as you would probably need to grind down to bare metal. I wouldn't want to be responsible for the paint job and that may just make me responsible. | |
| | jdmarti1
Jack
join:2004-06-15
Oilton, OK
| Re: Watertown Mount We went to a fab shop and had something built that looked like the cell phone mounts, it attached around the vent cap on top. I will try to find some pictures of them. The legs are then epoxied down to the tower. The epoxy works very well, this is what it is designed for. You only have to clean the area where you are actually putting the epoxy - so you do not damage the paint on the tower. DO NOT DRILL HOLES IN A WATER TOWER TOP!!! You will be opening a can of worms that you can't close.
--
»magicwisp.com | |
| | | LLigetfa
join:2006-05-15
Fort Frances, ON
| Re: Watertown Mount You still need a good grounding point and for that, you need to go down to bare metal. If there is a vent that you can get even a single guy/ground wire to, you could use it as a hold-down for a tripod.
There is available, green thermoplastic stuff used primarily in the pipeline industry as a dielectric anti-corrosion coating that you apply over jeeps with a torch. The stuff works better than hot glue and can be resoftened if need be. It is also marketed for boat repair. You can use it to cover the grounding point, probably best cad-welded. If you have a centre hold-down guy, you could hot glue down the tripod legs. | |
| | | |
|
