rcilink
Premium
join:2003-12-15
Manchester, NH
| reply to titan_
Serial Console pinouts for some of these devices
VTA-VR uses 38400 baud. (N,8,1)
My connections to the pins are marked by color, but you will see the idea:
For all the pinouts below, Pin 1 is the left-most pin if you are facing the front of the device.
DLINK VTA-VR
•pin 1 ... rcv (green wire)
•pin 2 ... GND (white1 wire)
•pin 3 ... 3.3v (white2 wire)
•pin 4 ... n/c
•pin 5 ... xmt (red wire)
-----------------------------
LINKSYS PAP2 V2.0
•pin 1 ... 3.3v (white2 wire)
•pin 2 ... xmt (red wire)
•pin 3 ... rcv (green wire)
•pin 4 ... n/c
•pin 5 ... GND (white1 wire)
-----------------------------
MOTOROLA VT1005v (VxWorks)
•pin 1 ... 3.3v (white2 wire)
•pin 2 ... GND (white1 wire)
•pin 3 ... xmt (red wire)
•pin 4 ... rcv (green wire)
-----------------------------
* As you can see, these pinouts are very different between each device! If you are unsure, check for +3.3v DC on the pin listed above to verify proper pinout. You can really trash your device if you get this wrong.
For some reason, I did not write down the Motorola VT2142 pinout. When I find it, I will add it here. |
