Search:  

 
 
   All ForumsHot TopicsGallery






how-to block ads


 
Forums » US Telco Support » AT&T » AT&T Southeast » how to setup new dsl access ACCOUNT w/o installing software
Share Topic:
RSS topic:
toggle:
flat / full
normal / watch
Posting:
Post a:
Post a:
Disconnecting/Reconnecting Issues »
« 327w firewall "state" rule times out in 10sec?!?  
STDog

join:2008-02-21
Starkville, MS


1 edit

Re: how to setup new dsl access ACCOUNT w/o using the install cd

I don't remember installing any software from the CD.

I connected to the route/modem, used the attreg user/pss to connect the modem.

I ran the setup tool, said it was my own modem.
It took me ti the registration page (I guess that the dslinstallation site, I couldn't find the address before).

I filled in the reginfo, got to the summary page, and exited.

Went back to the modem, changed the user/pass and reconnected.

It's worked fine since (Feb 25).
--
"Dependence begets subservience and venality, suffocates the germ of virtue, and prepares fit tools for the designs of ambition." --Thomas Jefferson
impala

join:2008-03-08
Clemson, SC
·AT&T Southeast

Re: how to setup new dsl access ACCOUNT w/o using the install cd

Click for full size
must install activeX software
Click for full size
after clicking cancel
see my screenshots:
First is the prompt to install the Motive software.
Second is after clicking cancel on the first page.

So, where can I specify my own modem? After motive doesn't detect it? It's too late then.
STDog

join:2008-02-21
Starkville, MS

Re: how to setup new dsl access ACCOUNT w/o using the install cd

That's an ActiveX concrol from Motive.

It for the stupid Guided installation w/ audio.

I did install that control, but I cannot find and AT&T software installed outside that control.

It's handles the modem detection, but it gave me a selection of 3 or 4 different modems or other. I chose other.

After the registration confirmation page (shows user/pass, security questions, etc..) I stopped. I didn't install any of the tools.

I forgot I had ActiveX allows in IE (I only use it for company apps than require).

It installs 3 dlls, but I have disabled them in IE. I normally use Firefox anyway. I'm sure I could delete them and the registry entries for them without iusse.
--
"Dependence begets subservience and venality, suffocates the germ of virtue, and prepares fit tools for the designs of ambition." --Thomas Jefferson
Forums » US Telco Support » AT&T » AT&T SoutheastDisconnecting/Reconnecting Issues »
« 327w firewall "state" rule times out in 10sec?!?  


Wednesday, 09-Dec 22:32:17 Terms of Use | Privacy Policy | Hosting by www.nac.net - DSL,Hosting & Co-lo | feedback | contact
over 10 years online! © 1999-2009 dslreports.com.
page compression OFF
Most commented news this week
· [200] Sprint Sued For Distracted Driving Death
· [107] AT&T Launching New 24 Mbps U-Verse Tier
· [82] 3G Network Test Says AT&T Is Tops
· [72] Mediacom Unveils 105 Mbps Pricing
· [66] Sprint Poised For A Turnaround?
· [64] WPA Cracker: Test WPA-PSK Networks In 20 Minutes
· [58] AT&T Hints At Usage-Based iPhone Data Pricing
· [51] The Future Of Wi-Fi Is Bright
· [47] Site Leaks Yahoo, Verizon Fed Data Share Pricing
· [44] Microwaving Your Innards Is Not 'Extreme'
Most people now reading
· Adobe Flash Player version 10.0.42.34 [Security]
· Hot Girl falls face first down stairs [56k Lookout (Broadband Heavy)]
· Is sleeping similar to being dead? [General Questions]
· Windows 7 boot manager editing questions [Microsoft Help]
· Road Runnner up to 50 mbps is ready ! [Road Runner]
· ICC Strats??? [World of Warcraft]
· RG Firmware update to VDSL2 this morning [AT&T U-verse]
· ICC strats [World of Warcraft]