seqrets
Premium
join:2001-05-03
Nederland, TX
clubs:
 ·RoadRunner Cable
| Hard starting power washer
Long story short, I purchased this PW from Lowe's yesterday and from the get go, it has been hard to start. On average it will take 6 pulls to start it. If it runs out of fuel, it takes longer "12 + pulls". This is a major pain in the ass! Starter fluid doesn't even help!
Does anyone have this model# 20295 ?
»www.lowes.com/lowes/lkn?action=p···age=none |
|
SandShark
So it goes
Premium,MVM
join:2000-05-23
Santa Fe, TX
clubs: | Are you priming it and using the choke? |
|
seqrets
Premium
join:2001-05-03
Nederland, TX
clubs:
·RoadRunner Cable
| Oh I want to Choke it believe me but, it doesn't have one. Throttle set to Fast/Run and used the Primer bulb as per instructions. Fuel is new and I don't see any trash in the can. Haven't had any problems with the same fuel in 2 other mowers.
If the gap in the spark plug out of spec would that effect it? Once it starts it runs fine. |
|
SandShark
So it goes
Premium,MVM
join:2000-05-23
Santa Fe, TX
clubs:
 ·Verizon Online DSL
| said by seqrets  :Oh I want to Choke it believe me... If the gap in the spark plug out of spec would that effect it? Once it starts it runs fine.  I know the feeling. Well, I'm thinking once it starts, it runs fine then the spark plug gap should be okay. I guess you could check it, since it's a fairly easy task, that is, if you have a spark plug gap gauge. The manual says 0.020 (0.50mm). Other than that, I don't know what else to recommend. I don't have a pressure washer, but I plan on getting one in the near future. I don't understand why it doesn't have a choke. All my engines have one.
--
Blog | • • • - - - • • • | Hunt's Treasure |
|
wth
Premium
join:2002-02-20
Iowa City, IA | reply to seqrets
On my Toro snow blower, the instructions say to hold the primer button in for a second B4 you take your finger off of it and repeat. So push, HOLD, release primer button. Give this method a try. |
|
HarryH3
join:2005-02-21
Georgetown, TX | reply to seqrets
I have a mower with the primer bulb and no choke. I found that a couple of extra bulb presses made it much easier to start when cold. |
|
seqrets
Premium
join:2001-05-03
Nederland, TX
clubs:
·RoadRunner Cable
| Thanks fellows! I finally finished the driveway. Next up is the patio and the area around the pool. I'll try stroking the bulb a little longer/slower and see if that helps "no pun intended"! If not, disassembly time, repackage and head back to Lowe's!  |
|
normat
Premium
join:2000-08-02
Boynton Beach, FL
clubs:
| reply to seqrets
My parents bought a different model that had a similar problem. They exchanged it for another and that one started much better.
My trimmer can be a real beast. I even injured my wrist one time trying to start that thing. I found if I added fuel stabilizers (even to new fuel) it seemed to start better. |
|
caddyroger
Premium
join:2001-06-11
clubs:
·Comcast
| reply to seqrets
said by seqrets :Long story short, I purchased this PW from Lowe's yesterday and from the get go, it has been hard to start. On average it will take 6 pulls to start it. If it runs out of fuel, it takes longer "12 + pulls". This is a major pain in the ass! Starter fluid doesn't even help! Does anyone have this model# 20295 ? » www.lowes.com/lowes/lkn?action=p···age=none On my weed wackier I don't have a choke on it. I have to press a primer buld on. Press slow on the bulb about 4 times and try that.
--
Caddy |
|
