bilbobbra
| reply to tipstir
Re: WLI-TX4-AG300N
I have since ordered and they do indeed connect however the buffalo will only connect at 130Mbs, the setting in the netgear is up to 270. Is there a way to boost this?
What is this firmware you mentioned?
Thanks |
|
tipstir
join:2004-11-14
Enfield, CT
 ·Cox HSI
| Wireless N 150MBps (actual speed) (300MBps chipset speed)
Wireless N 130MBps (actual speed) (260MBps chipset speed)
If you see 270MBPs link speed actual speed would be 1/2 that reported speed. 135MBps (actual speed)
130MBps, 135MBps and 150MBps is ideal.. |
|
bilbobbr
join:2005-11-07
Isle of Man
| Thanks for the reply. The netgear on my pc reports connected at 2x at 270Mbps using channels 1 & 5.
The Buffalo reports connected at 1x at 130Mbps using only channel one?
Will that be the 'actual' speed reported by the buffalo and will that be the same speed as the netgear which is saying 270? Or would the Buffalo be saying connected at 2x if it was at full speed?
Thanks for your help. |
|
lodestar
join:2005-08-23
England
1 edit | From what I can find of the spec for the WLI-TX4-AG300N on the web, this seems to be an important point
"...Four Built-in 10/100 Ports for up to 4 Simultaneous Wired Devices..."
So it seems to me that it does not matter what the reported wireless speed is. Devices plugged into the WLI-TX4-AG300N lan ports are limited to a maximum speed of 100Mbps. And of course although an operating system may show a 10/100 port as running or linked at 100Mbps in reality actual transfer speeds are more likely to be in the 60-70Mbps range.
In my opinon Buffalo should have fitted gigabit lan ports to the WLI-TX4-AG300N, that is 10/100/1000 speed which would at least have allowed wireless transfer rates in the 100Mbps+ range to have actually meant something. |
|
bilbobbr
join:2005-11-07
Isle of Man | That is a very good point. Isn't the actual throughput you get from wireless connected at 130Mbps a lot less than you would get from a wired 100Mbps though? |
|
lodestar
join:2005-08-23
England
1 edit | Yes I would have thought so, and Buffalo seem to be recognising that by only supplying 10/100 lan ports. I was intending to buy the WLI-TX4-AG300N for use with my Buffalo WZR-AG300NH router which does have gigabit lan ports. So it might well be able to exceed 10/100 lan port speeds but would not be able to demonstrate that in partnership with the WLI-TX4-AG300N. |
|
tipstir
join:2004-11-14
Enfield, CT
·Cox HSI
| The Gig LAN will only work at LAN speeds of the slower network device on your LAN. So if you have 100mbps and 1000mpbs then they'll fallback to that. I have that problem so I just place the 1000mbps on completely different setup. Since there is no 1000mbps for WAN yet even though routers have that feature. I only use my 1000mbps with Jumbo Frames on to transfer larger GIG files among themselves using the \\ipgig address. These desktops and servers have dual NICs. One is for the Megabyte WAN/LAN the other one is for GigLAN. |
|
