Re: [Wireless] Tomato firmware on buffalo - wireless issue

Author	All Replies
Rigaudon join:2008-05-03	reply to PeeWee Re: [Wireless] Tomato firmware on buffalo - wireless issue I've heard of that , but I'm not sure what that is. Are you asking if I did that prior to installing the new Buffalo Firmware? I recall seeing that as an issue when going back to Buffalo. At first I couldn't get in, but I hit the reset button for 20 seconds and then I could get in.
Rigaudon join:2008-05-03	to forum · permalink · · 2009-03-29 09:30:22 ·
PeeWee Premium join:2001-10-21 Clovis, CA clubs: ·Pacific Bell - SBC ·Comcast 1 edit	After update to Tomato. You should dump nvram, restart and then setup to run they way you want. There are setting for the external buttons that might not have been assigned properly. -- My grandkids ARE cuter than yours!
	to forum · permalink · · 2009-03-29 12:57:53 ·
PeeWee Premium join:2001-10-21 Clovis, CA clubs: ·Pacific Bell - SBC ·Comcast 1 edit	reply to Rigaudon said by Rigaudon : I've heard of that , but I'm not sure what that is. Are you asking if I did that prior to installing the new Buffalo Firmware? I recall seeing that as an issue when going back to Buffalo. At first I couldn't get in, but I hit the reset button for 20 seconds and then I could get in. Returns you to default settings, but does not clear nvram. -- My grandkids ARE cuter than yours!
	to forum · permalink · · 2009-03-30 02:48:28 ·


Monday, 14-Dec 17:50:19	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com. page compression OFF