| [Tomato] getting lan ip for wan ip Hi,
Could anyone have a clue for my wierdo problem. For a long time I've had my setup so that my adsl2+ modem (zyxel 660) is in bridge mode before the buffalo whr-g54 running the tomato firmware. Everything was fine until recently without any visible reason when i boot the buffalo (or renew the wan ip otherwise) I'm getting a local ip as the wan ip. I would assume that this was some kind of hassle with zyxel natting but shouldn't the bridge mode prevent such stuff from happening? I'm totally clueless with this one, could anyone have tip or two?
regards,
lateko |
|
 PhilRojo SolPremium
join:2001-06-11
Camarillo, CA
kudos:2 | Disable DHCP on the modem. |
|
|
|
| reply to ltko
said by ltko :
Hi,
Could anyone have a clue for my wierdo problem. For a long time I've had my setup so that my adsl2+ modem (zyxel 660) is in bridge mode before the buffalo whr-g54 running the tomato firmware. Everything was fine until recently without any visible reason when i boot the buffalo (or renew the wan ip otherwise) I'm getting a local ip as the wan ip. I would assume that this was some kind of hassle with zyxel natting but shouldn't the bridge mode prevent such stuff from happening? I'm totally clueless with this one, could anyone have tip or two?
regards,
lateko
You need to spend 4 hours on the phone to ask your ISP that question. |
|
| reply to ltko
Hi,
Big thanks for the help.. I finally got it to work. Indeed I had to disable DHCP (thought it would be turned of automatically when using bridge mode). Also I needed to remove the LAN ip I had forced for the modem. For some reason both of those needed to be done. |
|
PhilRojo SolPremium
join:2001-06-11
Camarillo, CA
kudos:2 | You're welcome and thanks for letting us know you got it working. |
|
