how-to block ads
NetFixerFrom my cold dead handsPremiumReviews:
|reply to JohnInSJ |
Re: Speed increase for businss starter - northeast
said by JohnInSJ:Yes, I power cycled my SB6121 and my SamKnows TL-WR1043ND box last night to make sure that some problems I had experienced several weeks ago with the SamKnows box had indeed been fixed, and I noticed that the SamKnows throughput results had gotten higher overnight. Those higher average throughput results have continued throughout the day. said by NetFixer:
But today, ShaperProbe and SamKnows show this for my 12/2 connection:
Did you power cycle? In San Jose CA, I am still showing:
Upstream: Burst size: 3273-3838 KB; Shaping rate: 2128 Kbps.
Downstream: Burst size: 19048-20179 KB; Shaping rate: 12768 Kbps.
which is the sad old speeds
An additional ShaperProbe test that I just ran:
said by ShaperProbe :and also the ICSI Netalyzr test:
DiffProbe release. January 2012. Build 1008.
Shaper Detection Module.
Connected to server 220.127.116.11.
Upstream: 11129 Kbps.
Downstream: 95737 Kbps.
The measurement will take upto 2.5 minutes. Please wait.
Checking for traffic shapers:
Upstream: Burst size: 4615-4909 KB;
Shaping rate: 3173 Kbps.
Downstream: Burst size: 9251-10130 KB;
Shaping rate: 17024 Kbps.
For more information, visit: »www.cc.gatech.edu/~partha/diffprobe
seem to point to the new 12/2 --> 16/3 speed tier change having been implemented at this location. I suspect that this is something that is being individually done at each franchise, so it probably won't happen at the same time everywhere in Comcast's footprint. FWIW, I do not see any evidence of a new config file having been installed in my SB6121 log display page, but I am not sure if that is even displayed with the SB_KOMODO-18.104.22.168-SCM00-NOSH SB61xx firmware.
We can never have enough of nature.
We need to witness our own limits transgressed, and some life pasturing freely where we never wander.
said by NetFixer:The only time I've seen the config file for my SB6120 show up in the log was during/after the 22.214.171.124 -> 126.96.36.199 upgrade. No amount of resets/reboots with either firmware got it to show up again. Here's when I saw it during the firmware upgrade, although that was when I had 50/10. I have no idea what the 22/5 one is named.
FWIW, I do not see any evidence of a new config file having been installed in my SB6121 log display page, but I am not sure if that is even displayed with the SB_KOMODO-188.8.131.52-SCM00-NOSH SB61xx firmware.
I did a reset/reboot a few minutes ago to see if the new speeds made it here yet. Unfortunately, no. Good to see that you got it though, I wasn't expecting them to roll it out until later (when companies say "by X month", I always assume at the very end of that timeframe ).