dslreports logo
site
 
    All Forums Hot Topics Gallery
spc

spacer




how-to block ads


Search Topic:
uniqs
5
share rss forum feed

urbang33k

join:2010-02-13
Canada
kudos:1

1 edit
reply to madmax4

Re: [Internet] Bell Fibe and Sagecom Connection Hub

well thats odd.

sounds like it could be an address conflict??

on your old setup, were you using your own router?

edit: I'll add that I use a voip ethernet ata on my sagemcom and it works just fine.


Paolo
Mr. Wireless

join:2004-05-29
canada
first thing first, do NOT use the red WAN/ETH port on the CONNECTION HUB, its not to be used, secondly, it sounds like you have an IP ADDRESS CONFLICT and was blaming your provider ALL THIS TIME. I would try to get to the bottom of the issue before blaming the provider, that way I dont look dumb when it turns out to be my issue all along. hope this helps
--
Happiness is like peeing your pants... Everyone can see it, but only you can feel its Warmth!!

madmax4

join:2008-10-25
York, ON
Which Provider Bell or Voip? anyway did some research using this intrepid forum and Toro suggested using another router so I put the Sagecom in Bridge mode and used my apple router using PPOE and NAT open. Phone now works fine Polycom 335 using Comwave