|reply to LazMan |
Re: Asus RT-N16 as secondary router, need DHCP on both routers
So you are suggesting LAN-LAN, which I already tried, turning Asus to slave/dummy.
I still don't know how would I assign static IPs using Linksys.
On Asus running Tomato, it's super easy, where one menu shows all discovered MAC addresses and you can add IPs right away.
1. How would Linksys "see" cameras that are discovered by Asus?
2. How should I manage SSID's and channels?
I'm not familar with that specific router, but the Googe-Fu is strong today...
Page 25 is DHCP reservations.
If the SSID's and WiFi are working through the Asus right now, I'd probably leave it alone, myself... No use fixing what isn't broken.
As for 'seeing' the cameras - if DHCP is disabled on the Asus - the Linksys will answer the DHCP requests from the cameras, assuming they are setup for DHCP now. Are they, or are they static?
Right now, all 6 wireless cameras have static addresses set up on tomato/Asus settings. 192.168.1.111, *112, *113, etc. Every unique MAC address is assigned it's own IP address.
They have to be static in order to work with multi camera software on laptop and to work through no-ip or similar DNS service, so camera footage can be seen online (away from the house) or on smartphone.
This is the exact setup I have myself at my home, except I am using just 1 router and set up was a breeze.
|reply to ba1drick |
Yes, if you connect a LAN port on the Asus to the switch, which is connected to the Linksys, disable DHCP on the Asus and assign the Asus an IP, you have effectively turned the Asus into an access point. The Linksys will see any wireless devices connected to the Asus router.
However, look at the documentation for the Asus. A Netgear router that I have here (wnr2000v3) has you use the WAN port for the connection, if you use the firmware that is inbuilt for the AP configuration. But it works fine using the steps in the first paragraph for configuration.
Technically, you don't assign static IP's for the cameras on the Linksys, you do it on each camera. Use IP's that are outside the DHCP scope (on Linksys routers, this scope ordinarily starts at .100)