·Future Nine Corp..
|reply to ke4pym |
Re: My addition will take almost 2 miles of Cat 6
said by ke4pym:Most of the wire is run and there is no problem (for me).
Get a better access point.
My cost will be approximately $4,000 for installation and $1,000 - $1,200 for all cables and connectors once it's all up. I'm comfortable with this. Others may not be. The server cost $600, I'll probably be paying nearly 1K per 48 port switch x 1 or 2. Cameras run $100 a piece times about 9.
In each bedroom, I anticipate one nearly full box of 7 Ethernet connectors used, and the other boxes mostly unused. I will only connect active cable to a switch (aside for testing).
I have yet to get very good streaming from any access point, and when multiple devices are streaming, failure is always the result.
You may have a different situation and better experience. For me, this is a solution that works. I was just amazed to think of wires by the mile instead of by the foot or meter which is how I usually think of them.
"If you put the federal government in charge of the Sahara Desert, in 5 years there'd be a shortage of sand." - Milton Friedman"