 JohnnyG101MafiaosoPremium
join:2000-12-25
Charlotte, NC
 ·RoadRunner Cable
| Vonage fast busy signal Just got my vonage setup, installed the ATA a few mins ago. I got dial tone but when i try to make a call after a few seconds i get a fast busy signal. (yes I am dialing 11 digits)
Also, when i get a call the phone rings but when i pick it up after 3 seconds it goes to a fast busy.
[text was edited by author 2003-08-13 17:33:02] |
|
JohnnyG101MafiaosoPremium
join:2000-12-25
Charlotte, NC | nevermind, figured it out.
--
gobble gobble |
|
| reply to JohnnyG101
you have to push the button on the ata then go for dial tone and dial 80#. |
|
|
|
 CamPremium
join:2003-01-25
Luther, OK | reply to JohnnyG101
said by JohnnyG101:
nevermind, figured it out.
Don't leave us hanging, what was the problem? |
|
JohnnyG101MafiaosoPremium
join:2000-12-25
Charlotte, NC | port wasnt fowarded
--
gobble gobble |
|
| I've been getting the fast busy signal intermittently with Vonage over the past several months. It seems like the problem happens more and more, to the point that I've hardly been able to even place a call. Tech support hasn't been much help. They told me to contact my cable provider about pack loss (which I did), and to upgrade the firmware on my router (which I did).
How did you check to see if the "port was forwardable"? |
|
| reply to JohnnyG101
My P8 has this problem where it will fast busy. I try to redial and it's still fast busy. I unplug the DTA and plug it back in and it works fine. Annoying. |
|
jarruda
join:2002-08-25
Pompano Beach, FL | said by prestonlewis:
My P8 has this problem where it will fast busy. I try to redial and it's still fast busy. I unplug the DTA and plug it back in and it works fine. Annoying.
I never had this problem (linux/iptables doing PPPoE over DSL setup), but it seems like a NAT boo-boo ?
Have you tried to have your DTA-310 as the DMZ box ? Have you called P8 support ? |
|
 blohner
join:2002-06-26
Cortlandt Manor, NY
·Optimum Online
 ·Verizon FiOS
 ·Google Voice
·ooma
·Vonage
| reply to akassover
Check the IP of your ATA (pickup phone, push red button, dial 80# - the british lady will tell).
Forward port 5060 and 5061 UDP on your router to the ATA.
See if it helps (solved my problem on the Linksys BEFSX41 - apparently the NAT table forgets entries every once in a while and then the ATA is not reachable for short periods of time)
--
I am addicted to speed --- OOL speed that is ---
~Help find a cure for cancer~Proud Member Team Discovery |
|
